ADTRAN 5000 Series - Manual (Page 448)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 448
snmp-server contact [email | pager | phone]
Use the snmp-server contact command to specify the email address, pager number, or phone number. Use
the no form of this command to remove a configured contact.
Syntax Description
email Specifies email address for the SNMP server contact.
pager Specifies pager number for the SNMP server contact.
phone Specifies phone number for the SNMP server contact.
Identifies the contact (up to 32 characters in length).
Default Values
No default values necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example specifies 6536999 for the pager number:
(config)#snmp-server contact pager 6536999