ADTRAN 5000 Series - Manual (Page 119)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 119
debug ip pim-sparse joinprune [event | state]
Use the debug ip pim-sparse joinprune command to display protocol-independent multicast (PIM)
sparse mode join and prune transactions. Debug messages are displayed (real time) to the terminal (or
Telnet) screen. Use the no form of this command to disable debug messages.
Syntax Description
event Displays PIM sparse join and prune events.
state Displays PIM sparse join and prune state changes.
Specifies group address to filter.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 2000, 5000, and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example activates PIM sparse mode messages for all join and prune events and state
changes:
>enable
#debug ip pim-sparse joinprune