ADTRAN 5000 Series - Manual (Page 386)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 386
ip local policy route-map
Use this command to specify a route-map for local policy routing on the device. This setting is applied to
the local network interface. Use the no form of this command to return to the default route-map.
Syntax Description
Specify the name of the route-map.
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Functional Notes
Before a route map can be specified, it must first be defined using the route-map command. See
route-map [ permit | deny ] on page 439 for more information.
Usage Examples
The following example specifies a route-map entitled myMap for local policy routing:
(config)#ip local policy route-map myMap