ADTRAN 5000 Series - Manual (Page 133)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 133
debug radius
Use the debug radius command to enable debug messages from the RADIUS subsystem. Debug messages
are displayed (real time) to the terminal (or Telnet) screen. Use the no form of this command to disable the
debug messages.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
The debug radius messages show the communication process with the remote RADIUS servers.
Usage Examples
The following is an example output for the debug radius command:
>enable
#debug radius
RADIUS AUTHENTICATION: Sending packet to 172.22.48.1 (1645).
RADIUS AUTHENTICATION: Received response from 172.22.48.1.