ADTRAN 5000 Series - Manual (Page 782)

Command Reference Guide HDLC Command Set
61200990L1-35E Copyright © 2005 ADTRAN 782
HDLC C OMMAND S ET
To activate the HDLC mode, enter the interface hdcl command at the Global Configuration mode prompt.
For example:
>enable
#configure terminal
(config)#interface hdlc 1
(config-hdlc 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy on page 784
alias link<“text”> on page 787
bandwidth on page 788
bridge-group on page 789
crypto map on page 790
dial-backup commands on page 792
dynamic-dns [dyndns | dyndns-custom | dyndns-static]
on page 808
fair-queue on page 810
hold-queue out on page 811
ip commands begin on page 812
keepalive on page 837
lldp receive on page 838
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 839