ADTRAN 5000 Series - Manual (Page 207)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 207
show ip interfaces [ | brief]
Use the show ip interfaces command to display the status information for all IP interfaces (or a specific
interface).
Syntax Description
Optional. Displays status information for a specific interface. If no interface is entered,
status information for all interfaces is displayed. Type show ip interfaces ? for a
complete list of applicable interfaces.
brief Displays an abbreviated version of interface statistics for all IP interfaces.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Release 9.1 Command was expanded to include HDLC and tunnel interfaces.
Release 11.1 Demand interface was added.
Usage Examples
The following is a sample output of the show ip interfaces command:
>enable
#show ip interfaces
eth 0/1 is UP, line protocol is UP
Ip address is 10.10.10.1
Netmask is 255.255.255.0
MTU is 1500
Fastcaching is Enabled
RIP Authentication is Disabled
RIP Tx uses global version value
RIP Rx uses global version value