ADTRAN 5000 Series - Manual (Page 121)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 121
debug ip pim-sparse register [event | state]
Use the debug ip pim-sparse register command to display protocol-independent multicast (PIM) sparse
source registration messages. Debug messages are displayed (real time) to the terminal (or Telnet) screen.
Use the no form of this command to disable debug messages.
Syntax Description
event Displays PIM sparse register events.
state Displays PIM sparse register state changes.
Specifies group address to filter.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 2000, 5000, and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example activates all PIM sparse registeration state changes:
>enable
#debug ip pim-sparse register state