ADTRAN 5000 Series - Manual (Page 528)

Command Reference Guide Ethernet Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 528
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy on page 530
arp arpa on page 533
bandwidth on page 534
bridge-group on page 535
crypto map on page 536
dynamic-dns [dyndns | dyndns-custom | dyndns-static] on
page 538
encapsulation 802.1q on page 540
full-duplex on page 541
half-duplex on page 543
ip commands begin on page 544
Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list
of valid commands. For example:
>enable
Password:xxxxx
#config term
(config)#int eth 0/1
(config-eth 0/1)#?
access-policy - Assign access control policy for this interface
alias - A text name assigned by an SNMP NMS
arp - Set ARP commands
bandwidth - Set bandwidth informational parameter
bridge-group - Assign the current interface to a bridge group
etc....