ADTRAN 5000 Series - Manual (Page 1063)

Command Reference Guide IKE Client Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1063
IKE C LIENT C OMMAND S ET
To activate the IKE Client mode, enter the crypto ike client command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#crypto ike client configuration pool ConfigPool1
(config-ike-client-pool)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
dns-server on page 1064
ip-range on page 1065
netbios-name-server on page 1066
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.