ADTRAN 5000 Series - Manual (Page 208)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 208
show ip local policy
Use the show ip local policy command to display information about the route-map used for local
policy-based routing.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000, 5000, and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Example
The following is sample output from this command:
>enable
#show ip local policy
Local policy routing is enabled, using route-map equal
route-map equal, permit, sequence 10
Match clauses:
length 150 200
Set clauses:
ip next-hop 10.10.11.254
Policy routing matches: 0 packets, 0 bytes
route-map equal, permit, sequence 20
Match clauses:
ip address (access-lists): 101
Set clauses:
ip next-hop 10.10.11.14
Policy routing matches: 2 packets, 172 bytes