ADTRAN 5000 Series - Manual (Page 1073)

Command Reference Guide IKE Policy Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1073
IKE P OLICY C OMMAND S ET
To activate the IKE Policy mode, enter the crypto ike policy command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#crypto ike policy 1
(config-ike)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
attribute on page 1074
client authentication host on page 1075
client authentication host xauth-type [generic | otp | radius] on page 1076
client authentication server list on page 1077
client configuration pool on page 1078
initiate [main | aggressive] on page 1079
local-id [address | asn1-dn | fqdn | user-fqdn] on page 1080
nat-traversal [allow | disable | force] on page 1082
peer [ | any] on page 1083
respond [main | aggressive | anymode] on page 1085
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.