ADTRAN 5000 Series - Manual (Page 1184)

Command Reference Guide Route Map Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1184
set default interface
Use the set default interface command to specify an output interface for the packet if there is no explicit
route destination. Multiple interfaces can be specified but they must be point-to-point. The router forwards
the packet along the first usable interface. Use the no form of this command to cancel output from the
specified interface.
Syntax Description
Sets default interface type. Type set default interface ? for a list
of valid interfaces.
Specifies the ID of the specified interface type.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 Series, and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example sets the default interface as PPP 1:
(config)#route-map MyMap permit 100
(config-route-map)#set default interface ppp 1