ADTRAN 5000 Series - Manual (Page 1043)

Command Reference Guide Crypto Map IKE Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1043
C RYPTO M AP IKE C OMMAND S ET
To activate the Crypto Map IKE mode, enter a valid version of the crypto map ipsec-ike command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#crypto map Map-Name 10 ipsec-ike
(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 1044
ike-policy on page 1045
match address on page 1046
set peer on page 1048
set pfs [group1 | group2] on page 1049
set security-association lifetime [kilobytes | seconds] on page 1050
set transform-set on page 1051
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.