ADTRAN 5000 Series - Manual (Page 1114)

Command Reference Guide Router (OSPF) Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1114
R OUTER (OSPF) C ONFIGURATION C OMMAND S ET
To activate the Router (OSPF) Configuration mode, enter the router ospf command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router ospf
(config-ospf)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
cross-connect <#>
on page 28
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
area default-cost on page 1115
area range [advertise | not-advertise] on page 1116
area stub [no-summary] on page 1117
auto-cost reference-bandwidth on page 1118
default-information-originate [always | metric | metric-type ] on page 1119
default-metric on page 1120
maximum paths on page 1121
network area on page 1122
redistribute connected [metric | metric-type | subnets] on page 1123
redistribute rip [metric | metric-type | subnets] on page 1124
redistribute static [metric | metric-type | subnets] on page 1125
summary-address on page 1126
timers lsa-group-pacing on page 1127
timers spf on page 1128