ADTRAN 5000 Series - Manual (Page 491)

Command Reference Guide Line (Telnet) Interface Config Command Set
61200990L1-35E Copyright © 2005 ADTRAN 491
L INE (T ELNET ) I NTERFACE C ONFIG C OMMAND S ET
To activate the Line (Telnet) Interface Configuration mode, enter the line telnet command specifying a
Telnet session(s) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line telnet 0 4
(config-telnet0-4)#
You can select a single line by entering the line telnet command followed by the line number (0-4). For
example:
>enable
#configure terminal
(config)#line telnet 2
(config-telnet2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-class in on page 492
accounting commands [ l l default] on page 493
authorization commands [ l l default] on page 494
line-timeout on page 495
login on page 496
login authentication on page 497
login local-userlist on page 498
password [md5] on page 499