ADTRAN 5000 Series - Manual (Page 470)

Command Reference Guide Line (Console) Interface Config Command Set
61200990L1-35E Copyright © 2005 ADTRAN 470
L INE (C ONSOLE ) I NTERFACE C ONFIG C OMMAND S ET
To activate the Line (Console) Interface Configuration mode, enter the line console 0 command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line console 0
(config-con 0)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
accounting commands [ l l default] on page 471
authorization commands [ l l default] on page 472
databits [7 | 8] on page 473
flowcontrol [none | software in] on page 474
line-timeout on page 475
login on page 476
login authentication on page 477
login local-userlist on page 478
parity [even | mark | none | odd | space] on page 479
password [md5] on page 480
speed on page 481
stopbits [1 | 2] on page 482