ADTRAN 5000 Series - Manual (Page 510)

Command Reference Guide E1 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 510
E1 I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the E1 Interface Configuration mode, enter the interface e1 command (and specify the E1
port) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface e1 1/1
(config-e1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through] on page 511
coding [ami | hdb3] on page 512
framing [crc4] on page 513
loop-alarm-detect on page 514
loopback network [line | payload] on page 515
loopback remote v54 on page 516
remote-alarm [rai | ais] on page 517
remote-loopback on page 518
sa4tx-bit [0 | 1] on page 519
show test-pattern on page 520
snmp trap line-status on page 521
snmp trap link-status on page 522
snmp trap threshold-reached on page 523
tdm-group timeslots <1-31> speed [56 | 64] on page 524
test-pattern [clear | insert | ones| p215 | p220 | p511 | qrss | zeros] on page 525
ts16 on page 526