ADTRAN 5000 Series - Manual (Page 1169)

Command Reference Guide Radius Group Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1169
R ADIUS G ROUP C OMMAND S ET
To activate the Radius Group mode, enter the aaa group server command at the Global Configuration
mode prompt. For example:
>enable
#configure terminal
(config)#aaa group server radius myServer
(config-sg-radius)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
server [acct-port | auth-port ] on page 1170