ADTRAN 5000 Series - Manual (Page 569)

Command Reference Guide Ethernet Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 569
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface.
Syntax Description
1 Accepts only RIP version 1 packets received on the interface.
2 Accepts only RIP version 2 packets received on the interface.
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 2000, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Release 5.1 Command was expanded to include Ethernet sub-interfaces.
Functional Notes
Use the ip rip receive version command to specify a RIP version that overrides the version (in the
Router RIP) configuration. Refer to
version [1 | 2] on page 1144 for more information.
The AOS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the Ethernet interface to accept only RIP version 2 packets:
(config)#interface eth 0/1
(config-eth 0/1)#ip rip receive version 2