Edwards Signaling eFSA250 - Manual (Page 84)

Chapter 2: Front panel programming
72 E-FSA64 and E-FSA250 Technical Reference Manual
3. Press Enter to save the label and go to the next
number of the device.
Note: Pressing the Enter button saves the current
label and displays the next device number. This
lets you move quickly from one device to the next.
4. Repeat steps 2 and 3 until all devices are labeled.
5. When you have finished labeling, place the cursor
on the device number, and press the Cancel
button to continue with the next incremental
programming option.
See “Programming relay and sounder detector bases” on page 103.
Labeling zones
If you set the Label Zones incremental programming option to Yes, follow these
steps to label zones.
To label zones:
1. Enter the zone number to be labeled.
2. Enter a text label for the zone (two lines of 20
characters). The default label is “Zone XX.”
3. Press Enter to save the label and go to the next
zone number.
Note: Pressing the Enter button saves the current
label and then goes to the next zone number so
that you can quickly go to each zone and label it.
4. Enter a text label for the zone (two lines of 20
characters).
5. Repeat steps 3 and 4 until all zones are labeled.
6. When you have finished labeling, move the cursor
to the zone number, and then press the Cancel
button to continue with the next incremental
programming option.
Zone 01>
Label goes here
Label continued