Edwards Signaling Genesis Temporal Horn - Manual

© 2013 UTC Fire & Security. All rights reserved. 1 / 4 P/N 3100558 • REV 04 • REB 30JAN13
Genesis Temporal Horn Installation Sheet
Description
The Genesis Temporal Horn is an audible fire alarm
notification appliance designed for indoor walls. See Table 1
for a list of model numbers.
The horn includes field configurable jumper options for
selecting:
• Temporal or steady horn output (see Figure 1 item 1)
• High dB or low dB output (see Figure 1 item 2)
Table 1: Models
Description Number
Temporal horn,
white ADTG1-HD MG1-HD
EG1-HD XLSG1-HD
G1-HD ZG1-HD
G1-HD-LG
Temporal horn,
white, with FIRE marking ADTG1F-HD MG1F-HD
EG1F-HD XLSG1F-HD
G1F-HD ZG1F-HD
G1F-HD-LG
Temporal horn,
red ADTG1R-HD MG1R-HD
EG1R-HD XLSG1R-HD
G1R-HD ZG1R-HD
G1R-HD-LG
Temporal horn,
red, with FIRE marking ADTG1RF-HD MG1RF-HD
EG1RF-HD XLSG1RF-HD
G1RF-HD ZG1RF-HD
G1RF-HD-LG
Trim plate,
white ADTG1T MG1T
EG1T XLSG1T
G1T ZG1T
G1T-LG
Trim plate,
white, with FIRE marking ADTG1T MG1T
EG1T XLSG1T
G1T ZG1T
G1T-LG
Trim plate,
red ADTG1RT MG1RT
EG1RT XLSG1RT
G1RT ZG1RT
G1RT-LG
Trim plate,
red, with FIRE marking ADTG1RT MG1RT
EG1RT XLSG1RT
G1RT ZG1RT
G1RT-LG
Installation
Install this device in accordance with applicable requirements
in the latest editions of the NFPA codes and standards; the
National Building Code of Canada; the Canadian Electrical
Code, Part 1, Section 32, and in accordance with the local
authorities having jurisdiction.
Caution: Electrical supervision requires breaking the wire run
at each terminal. Do not loop the signaling circuit field wires
around the terminals.
To install the horn:
1. Remove the cover by depressing both tabs on the top of
the unit with a small screwdriver and twisting slightly.
2. Set the horn signal and sound output level to desired
settings. See Figure 1.
3. Connect the horn terminals to the signal circuit field wiring.
Observe polarity for the unit to function properly. See
Figure 1.
4. Mount the unit onto a compatible electrical box, making
sure not to overtighten the mounting screws.
5. Replace the cover by aligning at the bottom, then
snapping in at the top.
6. Test the unit for proper operation.
Figure 1: Horn settings
J2 J3 J1
1
2
1. To change the horn signal from temporal to steady, cut from circle
J2 to edge of circuit board
2. To change the horn sound output level from high dB to low dB.
cut J3 by snipping the board trace between holes