Edwards Signaling eFSA250 - Manual (Page 7)

E-FSA64 and E-FSA250 Technical Reference Manual v
Important information
Limitation of liability
This product has been designed to meet the requirements of NFPA 72 National
Fire Alarm and Signaling Code, UL 864 Standard for Control Units and
Accessories for Fire Alarm Systems, and ULC-S527 Standard for Control Units
for Fire Alarm Systems. Installation in accordance with this manual, applicable
codes, and the instructions of the authority having jurisdiction (AHJ) is
mandatory. UTCD Fire & Security shall not under any circumstances be liable for
any incidental or consequential damages arising from loss of property or other
damages or losses owing to the failure of UTC Fire & Security products beyond
the cost of repair or replacement of any defective products. UTC Fire & Security
reserves the right to make product improvements and change product
specifications at any time.
While every precaution has been taken during the preparation of this manual to
ensure the accuracy of its contents, UTC Fire & Security assumes no
responsibility for errors or omissions.
FCC compliance statement
This equipment can generate and radiate radio frequency energy. If the
equipment is not installed in accordance with this manual, it may cause
interference to radio communications. This equipment has been tested and found
to comply with the limits for Class A computing devices pursuant to Subpart B of
Part 15 of the FCC Rules. These rules are designed to provide reasonable
protection against such interference when this equipment is operated in a
commercial environment. Operation of this equipment is likely to cause
interference, in which case the user, at his own expense, will be required to take
whatever measures may be required to correct the interference.
SA-DACT FCC information
Cautions
• To ensure proper operation, this dialer must be installed according to the
enclosed installation instructions. To verify that the dialer is operating properly
and can successfully report an alarm, it must be tested immediately after
installation, and periodically thereafter, according to the enclosed test
instructions.