Edwards Signaling eFSA250 - Manual (Page 81)

Chapter 2: Front panel programming
E-FSA64 and E-FSA250 Technical Reference Manual 69
label, and then goes to the next zone number so
that you can quickly go to each zone and label it.
4. Enter a text label for the zone (two lines of 20
characters).
5. Repeat steps 3 and 4 until all zones are labeled.
6. When you have finished labeling, make sure the
cursor is on the zone number, and then press the
Cancel button to exit and go to the next auto
programming option.
Performing incremental programming
Incremental programming lets you add and label devices and zones to an
existing database without affecting current settings. It is typically used to add or
remove a device loop or a large number of individual devices. Incremental
programming should be used only after the panel has been program either by
auto programming or advanced programming.
Incremental programming options
Table 23 below describes the options to be set when performing incremental
programming.
Table 23: Incremental programming options
Device option Description
Loop Select the loop (number) that you want to program, or select All to program all
loops.
Label devices Yes: Enables device labeling
No: Disables device labeling
Label zones Yes: Enables zone labeling
No: Disables zone labeling