Edwards Signaling eFSA250 - Manual (Page 112)

Chapter 2: Front panel programming
100 E-FSA64 and E-FSA250 Technical Reference Manual
Option Description
AC power.
Remote drill: For a remote switch used to start the panels drill operation.
Remote reset: For a remote switch that when activated, resets the panel.
Remote signal silence: For a remote switch that when activated, silences
the NACs connected to the panel.
Smoke: For modules wired to a Class B circuit composed only of four-wire
smoke detectors. Modules with this device type trigger active (alarm)
events.
Smoke Class A: For modules wired to Class A circuits composed only of
four-wire smoke detectors. Modules with this device type trigger active
(alarm) events.
Supervised output: For modules wired to Class B circuits that output an
unsynchronized signal that does not turn off when you press Signal
Silence.
Supervised output Class A: For modules wired to Class A circuits that
output an unsynchronized signal that does not turn off when you press
Signal Silence.
Supervised output Class A (latched): For latched output modules wired to
Class A circuits that output an unsynchronized signal that does not turn off
when you press Signal Silence.
Supervised output (latched): For latched output modules wired to Class B
circuits that output an unsynchronized signal that does not turn off when
you press Signal Silence.
Supervised output Class A: For modules wired to Class A circuits that
output an unsynchronized signal that does not turn off when you press
Signal Silence.
Supervisory latching: For supervisory devices. Momentary activation of
normally open devices immediately places the panel in a supervisory state
and turns on supervisory LEDs and relays. Circuit cannot be restored until
devices are restored to normal and the panel is reset.
Supervisory Latching Class A: For modules wired to Class A circuits
composed only of supervisory switches. Modules with this device type
trigger active (supervisory) events. The module remains active until the
condition that activated it is restored and the control panel is reset.
Supervisory nonlatching: For supervisory devices. Momentary activation of
normally open devices immediately places the panel in a supervisory state
and turns on the supervisory LED and relay. Annunciation remains active
until the input restores. The panel does not have to be reset.
Supervisory nonlatching Class A: For modules wired to Class A circuits
composed only of supervisory switches. Modules with this device type
trigger active (supervisory) events. The module remains active until the
condition that activated it is restored. Resetting the control panel is not
required.
Unlatch outputs: For modules used to unlatch all latched outputs. The