Edwards Signaling 101XBRM Series - Manual

Figure 1. Dimensions
Description
Edwards AdaptaLight Series 101XBRM Stackable Beacon
is a unique signaling appliance which can contain up to five
modules, stacked onto a single AdaptaLight Base Unit (as
illustrated above). The 101XBRM series can be combined
or stacked with any of the models shown in Table 2 only if
modules have same input voltage. The 101XBRM LED Se-
ries is supplied in steady-on mode but offers a field-selectable
65 fpm flash mode. Up to five modules can be used in any
position in the AdaptaLight Stackable Beacon.
The AdaptaLight base unit (101BS) contains a mini pulsating
horn rated 85 dB at 10 feet (3.05 m). This horn can operate
as a sixth independent signal or with any one of the stacked
modules shown in Table 2. The base unit has a screw-type
terminal strip for positive hard wiring. Each module in the
stack is electrically interconnected through solid copper
busses and mating contacts to withstand vibration. Each is
positively connected to the one below it by a solid through-
bolt for mechanical integrity.
AdaptaLight is UL and cUL listed for direct surface or pipe
mounting in non-hazardous dust and outdoor applications.
The AdaptaLight may be mounted vertically with lenses facing
up or with lenses facing down (on ceiling). The AdaptaLight
is not suitable for outdoor installations when mounted with
the lenses facing down. The AdaptaLight must never be
mounted horizontally. Assemble and install in accordance
with these instructions.
The AdaptaLight modules have double fresnel polycarbonate
lenses available in a variety of colors, each providing a 360°
non-shadowed light pattern.
Mechanical Specifications
Outdoor Locations
Temperature Ratings ........... -31F to +150F (-35C to +66C)
PLC Compatibility
The electrical input load requirements for PLC compatible
signaling devices are listed in Table 1. Signaling devices
may be directly connected to output cards that meet these
input load requirements. Unit is PLC compatible only when
in steady mode.
Installation
To prevent electrical shock, do not connect
power until instructed to do so.
WARNING
This equipment must be installed by a qualified electrician in
accordance with the latest edition of the National Electrical
Code and applicable local codes.
1. Mount the base vertically either facing up or down using
one of the following procedures (Figures 2 and 3).
NOTE: For indoor applications, the base may be direct
surface mounted, mounted on a 4" (102 mm)
octagon box, or mounted on 1/2" NPT conduit.
For outdoor (weatherproof) applications, the base
must be conduit mounted vertically facing up.
a. Loosen the screw in the clamp ring, remove ring and
set aside.
NOTE: A permanently affixed gasket is supplied on the
base. Use care when handling the base unit to
prevent tearing of the gasket.
7 3/4” (197 mm)
3 lbs (1.4 kg)
11 3/8” (289 mm)
4 lbs (1.8 kg)
15” (381 mm)
5 lbs (2.3 kg)
18 5/8” (473 mm)
6 lbs (2.7 kg)
22 1/4” (565 mm)
7 lbs (3.2 kg)
P/N 3101631 ISSUE 3
© 2010
http://www.edwardssignaling.com Phone: (800) 336-4206 Fax: (800) 454-2363