Edwards Signaling eFSA250 - Manual (Page 77)

Chapter 2: Front panel programming
E-FSA64 and E-FSA250 Technical Reference Manual 65
Option Description
See “Factory default settings” on page 36.
Event: Only the event type (alarm, supervisory,
trouble, etc.) is reported or transmitted, no device
or zone information. This setting uses the default
CMS event notification settings for reporting
events. See “Factory default settings” on page 36.
Account 2 Account ID: Enter four-digit ID code for account 2
Primary receiver number: Enter the primary
receiver’s phone number (up to 20 digits).
Secondary receiver number: Enter the secondary
receiver’s phone number (up to 20 digits).
Format: CID
CID: Contact ID is the alarm format that the
monitoring facility (DACR) will receive. See
“Default contact ID event codes” on page 40.
Event notification: Set event notification (event
reporting) to:
Device: Only device information is reported or
transmitted, no zone information. This setting uses
default device event notification settings for
reporting events. See “Factory default settings” on
page 36.
Zone: When a device is a member of a zone, only
the zone information is reported or transmitted, no
device information. This setting uses default zone
event notification settings for reporting events.
See “Factory default settings” on page 36.
Event: Only the event type (alarm, supervisory,
trouble, etc.) is reported or transmitted, no device
or zone information. This setting uses the default
CMS event notification settings for reporting
events. See “Factory default settings” on page 36.
[1] Dialer options are displayed only if a dialer is installed on the panel.