Edwards Signaling eFSA250 - Manual (Page 128)

Chapter 2: Front panel programming
116 E-FSA64 and E-FSA250 Technical Reference Manual
Option Description
- Loop 1 initializing
- Loop 1 uncfgrd alarm
- Loop 1 map mismatch
- Loop 1 over limits
- Loop 1 device 000
- Loop 1 mapping
- Loop 1 map fault
- Loop 2 initializing
- Loop 2 map mismatch
- Loop 2 over limits
- Loop 2 device 000
- Loop 2 mapping
- Loop 2 map fault
- System startup
- Reset
- Reset/Sil inhibit
- Panel silence
- Program mode
- Signal silence
- Date - Drill
- Walk test
- Test fire
- Time
- Clear history
- Common alarm
- Common disable
- Common monitor
- Common supervisory
- Common trouble
- Battery charger
- Battery low
- Battery missing
- Local AC power
- System-wide AC power
- Self test fault
- Dialer dsbl/rem disc
- Dialer normal test
- Dialer abnormal test
- Dialer configuration
Event notification Note: Programming event notification here is only required if
you selected “Event” as your dialer account or network event
notification setting. See“Dialer programming” on page 117 or
“CMS network (transmitter) programming” on page 120.
Set the alarm, supervisory, monitor, trouble, disable, prealarm,
alarm verify, maintenance alert, and test event information by
choosing one and then setting the notification information.
When you have finished, choose Save. See “Factory default
settings” on page 36 for CMS device event notification default
settings.
Dialer:
• Acct 1 2: Event information is sent to both dialer accounts
• Acct 1: Event information is sent to dialer account one
• Acct 2: Event information is sent to dialer account two
• None: Event information is not sent to the dialer
NET (1-8): Yes or No. Controls whether event information is
sent to the connected network
CID: Contact ID event code (000 to 999)