Edwards Signaling eFSA250 - Manual (Page 186)

Chapter 3: System operation
174 E-FSA64 and E-FSA250 Technical Reference Manual
• The disabled and active points indicators on the LCD increment.
• The LCD displays a message indicating which loop event is disabled.
Not all events can be disabled. Those that cannot are labeled as “forbidden.” The
following table lists events that can be disabled.
Table 45: Loop events that can be disabled
Event
ID
Loop 1 fault 001
Loop 2 fault 011
Loop 1 card fault 003
Loop 2 card fault 013
Loop 1 unconfigured alarm 004
Loop 2 unconfigured alarm 014
Loop 1 unconfigured trouble 005
Loop 2 unconfigured trouble 015
To disable or enable a loop event:
1. Press the Menu button and choose Control.
2. Enter a level one password.
3. Choose Enable/Disable.
4. Choose Loop Event.
5. Select the loop event type that you want to disable
or enable.
See “Event ID numbers and descriptions” on page
154 for event descriptions and the list above for
the events that can be disabled.
6. Press Enter.
7. Press Cancel to return to the previous menu.
— or —
Press the Menu button to exit menu mode.
Control
Reports
Test
Control
Program

Enter Password
0000
Control
Enable/Disable
Activate/Restore

Enable/Disable
Zone
Panel Event
Loop Event

Loop Event Disable<>
001
Event 001
— or —
Loop Event Enable<>
001
Event 001