Edwards Signaling eFSA250 - Manual (Page 80)

Chapter 2: Front panel programming
68 E-FSA64 and E-FSA250 Technical Reference Manual
Labeling devices
If you set the Label Devices auto programming option to Yes, follow these steps
to label the devices.
To label devices:
1. Next to “Device,” enter the device number to be
labeled.
2. Enter a text label for the device (two lines of 20
characters). The default label is “Loop X Device
XXX.”
3. Press Enter to save the label and go to the next
number of the device.
Note: Pressing the Enter button saves the current
label, and then goes to the next available device,
so that you can quickly go to each device and label
it.
4. Enter a text label for the device (two lines of 20
characters).
5. Repeat steps 3 and 4 until all devices are labeled.
6. When you have finished labeling, place the cursor
in the device number field, and then press the
Cancel button to reopen the previous menu.
Continue with the next auto programming option.
Loop 1 Device 001
Label goes here
Label continued
See “Programming relay and sounder detector bases” on page 103.
Labeling zones
If you set the Label Zones auto programming option to Yes, follow these steps to
label zones.
To label zones:
1. Next to “Zone,” enter the number of the zone to be
labeled.
2. Enter a text label for the zone (two lines of 20
characters). The default label is “Zone XX.”
3. Press Enter to save the label and go to the next
number of the zone.
Note: Pressing the Enter button saves the current
Zone 01>
Label goes here
Label continued