Intel STRONGARM SA-1100 - Manual (Page 291)

SA-1100 Developer’s Manual 11-141
Peripheral Control Module
The following table shows the bit locations corresponding to the status bits within UART status
register 0. Note that the reset state of all writable status bits is unknown (indicated by question
marks) and must be cleared (by writing a one to them) before enabling the UART. Also note that
writes to reserved bits are ignored and reads return zeros.
.
Address: 0h 8005 001C UTSR0 Read/Write & Read-Only
Bit 7 6 5 4 3 2 1 0
Reserved EIF REB RBB RID RFS TFS
Reset 0 0 0 ? ? ? 0 0
Bit Name Description
0 TFS Transmit FIFO service request (read-only).
0 – Transmit FIFO is more than half-full (five or more entries filled) or transmitter
disabled.
1 – Transmit FIFO is half-full (four or fewer entries filled) and transmitter operation is
enabled, DMA service request signalled, and interrupt request signalled if not masked (if
TIE=1).
1 RFS Receive FIFO service request (read-only).
0 – Receive FIFO contains seven or fewer entries of data or receiver disabled.
1 – Receive FIFO is one- to two-thirds full (contains 5, 6, 7, or 8 entries of data) or more,
and receiver operation is enabled, DMA service request signalled, and interrupt request
signalled if not masked (if RIE=1).
2 RID Receiver idle.
0 – Receiver is busy, receive FIFO is empty, or receiver is disabled.
1 – Receiver is enabled, receive FIFO not empty, 3 frame times elapsed without
receiving data, request interrupt.
3 RBB Receiver begin of break.
0 – No break detected.
1 – Null character followed by parity and stop bits containing zeroes received, request
interrupt.
Note: Setting this bit allows the setting of REB, and also prevents further null characters
with framing errors from being stored in the receive FIFO (only one stored).
4 REB Receiver end of break.
0 – No end of break detected.
1 – Beginning of break was detected (interlock set) and a rising edge detected on the
receive pin, request interrupt.
Note: Setting of this bit allows the setting of RBB, and also allows characters to once
again be stored in the receive FIFO.
5 EIF Error in FIFO (read-only).
0 – Bits 8..10 are not set within any of the four bottom entries of the receive FIFO,
receive FIFO DMA service requests are enabled.
1 – One or more error bits (8..10) are set within one or more of the bottom four entries of
the receive FIFO, request interrupt, disable receive FIFO DMA service requests.
7.. 6 — Reserved.