Efficient Networks Siemens Sinamics S120 - Manual (Page 41)

Infeed
1.3 Basic Infeed
Drive Functions
Function Manual, (FH1), 07/2007 Edition, 6SL3097-2AB00-0BP4
41
Switching on the Basic Line Module
32:(521
63RZHURQGLVDEOH
=6:$(
=6:$(
65HDG\WRSRZHUXS
=6:$(
=6:$(
/LQHFRQWDFWRULV2))
:DLWIRUSRZHURQ
6D/LQHFRQWDFWRU
6ZLWFKRQSUHFKDUJLQJ
2))
67:$(
2))67:$(
2))67:$(
&RPPLVVLRQLQJFRPSOHWH
S DQGS
S
21
GHOD\
!32:(521 9HOHFWURQLFV
VXSSO\2))!21
RU5(6(7EXWWRQ
!67:$([[ FRQWUROZRUG
352),%86VXSSO\ELW[[
=6:$([[ VWDWXVZRUG
352),%86VXSSO\ELW[[
!
!U RSHUDWLQJGLVSOD\
62SHUDWLRQ
=6:$(
=6:$(
3XOVHVDQGFRQWUROOHUV
HQDEOHG9GFYLDUDPS
UDPSHGXS
!
!
7
!
!
!
!
!
[
!
Figure 1-9 Basic Infeed power-up
Note
Under the condition that the drive system was commissioned with STARTER and no
PROFIdrive telegram was activated, the infeed can be powered-up by issuing an enable
signal at the EP terminals and a positive signal edge at OFF1 (p0840).
Switching off the Basic Line Module
To switch off the Active Line Module, carry out the steps for switching it on in reverse order.
Switching off the controller with the OFF1 signal is delayed by the time entered in p3490.
This allows the attached drives to be braked in a controlled manner.