Rockwell Automation 1426 PowerMonitor 5000 Unit - Manual (Page 73)

Rockwell Automation Publication 1426-UM001F-EN-P - November 2013 73
Chapter
5
Power Quality Monitoring
a
This section describes the functions of the PowerMonitor 5000 unit. Most
functions require you to configure set-up parameters to align the unit with your
installation and your application requirements. The set-up parameters are listed
by name and described in this section. You can view set-up parameters by using
the PowerMonitor 5000 web page, and when logged in to an Admin account,
make changes to the setup. Set-up parameters are also accessible by using
communication.
Please refer to the Data Tables for additional information on setup parameters
including the following:
• Range of valid values
• Default values
• Data type
Set-up parameters can be found in data tables with names beginning with
‘Configuration’, for instance Configuration.Metering_Basic.
Topic Page
Harmonic Analysis 75
Sag and Swell Detection 79
Power Quality Event Classification (M6 model) 81
Short Duration RMS Variations (Category 2.0 - Sags, Swells, and Interruptions) (M6 model) 82
Long Duration RMS Variations (Category 3.0 - Undervoltage, Overvoltage, Sustained
Interruptions) (M6 model) 84
Power Quality Event Example 85
Voltage and Current Imbalance (Category 4.0) 87
Waveform Distortion (Category 5.1 - DC Offset, and 5.2 - Harmonics) (M6 model) 88
Power Frequency Variations (Category 7.0) 89
IEEE 519 Pass/Fail Capability (M6 model) 90
IEEE 519 Pass/Fail Results 91
IEEE519_Overall_Status 91
IEEE-519 Short Term and Long Term Harmonic Results 92
Waveform Recording (M6 model) 93