Rockwell Automation 1426 PowerMonitor 5000 Unit - Manual (Page 46)

46 Rockwell Automation Publication 1426-UM001F-EN-P - November 2013
Chapter 3 Setup
EXAMPLE This example explains how to change from a DHCP-assigned to a static IP address.
The initial network configuration is shown below. The IP address assigned is 192.168.200.8. The network
administrator has provided a range of static IP addresses in the same subnet, beginning with
192.168.200.100. In this case, the default gateway and DNS servers remain the same for static or DHCP-
obtained addresses (verify if this is true in your case with your network administrator).
To change to the new address, from the IP_Address_Obtain pull-down menu choose Static, type in the new
IP address, and click Apply Changes.
IMPORTANT You can change the network configuration from the USB or network web
pages. If you change the IP address from the network Web interface, you need
to browse to the new IP address to re-establish communication.