Rockwell Automation 1426 PowerMonitor 5000 Unit - Manual (Page 42)

42 Rockwell Automation Publication 1426-UM001F-EN-P - November 2013
Chapter 3 Setup
Open the Internet Explorer browser and browse to http://192.168.169.3. The
PowerMonitor 5000 home page displays in your browser as shown below. The
home page displays general information about the PowerMonitor 5000 unit. You
can navigate by clicking folders and pages from the tree on the left.
Initial setup by using the USB Web interface includes at least the following
configuration steps:
• Basic Metering - this aligns the power monitor metering functionality with
the properties of the circuit to which it connects
• Native Ethernet Network Communication - this permits access to the unit
for data monitoring and setup through an Ethernet network
• Optional Communication - this permits access to the unit for data
monitoring and setup through an optional communication card
• Date and Time - this sets the unit's internal clock so that time stamps in
logged data are correct
• Security (if desired) - enabling and configuring security guards against
unauthorized changes to the power monitor configuration
Once initial setup has been completed, including configuration of the Ethernet
IP address, you can also access the Web interface from a computer connected
through a network to the PowerMonitor 5000 unit’s native Ethernet port. Open
the Internet Explorer browser and browse to the IP address of the unit.