Rockwell Automation 1426 PowerMonitor 5000 Unit - Manual (Page 51)

Rockwell Automation Publication 1426-UM001F-EN-P - November 2013 51
Chapter
4
Metering
This section describes the functions of the PowerMonitor 5000 unit. Most
functions require you to configure set-up parameters to align the unit with your
installation and your application requirements. The set-up parameters are listed
by name and described in this section. You can view set-up parameters by using
the PowerMonitor 5000 web page, and when logged in to an Admin account,
make changes to the setup. Set-up parameters are also accessible by using
communication.
Please refer to the Data Tables for additional information on setup parameters
including the following:
• Range of valid values
• Default values
• Data type
Set-up parameters can be found in data tables with names beginning with
‘Configuration’, for instance Configuration.Metering_Basic.
Basic Metering The PowerMonitor 5000 unit calculates metering results based on the values of a
number of set-up parameters. These basic metering parameters are listed in the
table that follows. The basic metering setup is necessary to obtain accurate,
properly scaled metering results.
This applies to all models of the PowerMonitor 5000 unit.
Topic Page
Basic Metering 51
Wiring Diagnostics 53
Wiring Correction 57
Metering Overview 60
Energy Metering 61
Demand Metering 62
Power Metering 67
Voltage, Current, Frequency Metering 69
Configuration Lock 71