Allied Telesis AT-S97 - Manual (Page 98)

Chapter 5: Port and Module Commands
98
This command disables all of the twisted pair ports in the media converter
module in slot 1. The chassis has the ID number of 1:
system set port id=1/1/a port-state=disable
This command sets the duplex mode to half-duplex for all the fiber optic
ports in the media converter module in slot 2. The chassis has the ID
number of 1:
system set port id=1/2/b duplex=half
The SYSTEM SET PORT command can also be used to configure the 10/
100/1000Base-T Management port on the management module. This
example disables Auto-Negotiation on the port and sets it to 100 Mbps,
full-duplex. The chassis has the ID number of 0:
system set port id=0/m auto-neg=disable speed=100
duplex=full