Allied Telesis AT-S97 - Manual (Page 65)

AT-S85 and AT-S97 Management Software User’s Guide
65
SYSTEM SET LOCATION
Syntax
system set location= location
Parameters
location Specifies a location for a chassis or stack. A location can
be of up to 25 alphanumeric characters. Spaces are
allowed, but a location with spaces must be enclosed in
double quotes (“ “). To remove the current value without
specifying a new value, enter “none.”
Privilege Levels
Administrator and read-write.
Description
This command is used to specify a location of a chassis or stack. This
information can be helpful in locating the different media converter units in
your network. To view the current value for this parameter, refer to
“SYSTEM SHOW INFO” on page 69.
Examples
This command sets a stack’s location to “Bldg 3, rm 212:”
system set location="Bldg 3, rm 212"
This command removes the current location without assigning a new
value:
system set location=none