Diagnostics show chassis, Figure 45: diagnostics show chassis eeprom command – Allied Telesis AT-S97 User Manual
Page 230
Chapter 14: Diagnostics Commands
230
DIAGNOSTICS SHOW CHASSIS
Syntax
diagnostics show chassis id=
chassis
eeprom
Parameters
id
Identifies the ID number of a chassis. You can specify only
one chassis at a time. The range is 0 to 31. To view a unit’s
ID number, see “SYSTEM SHOW CLUSTER” on
page 101. For background information, refer to “Chassis ID
Numbers” on page 25.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command is used to display hardware information about the modules
in a chassis. You may need to provide this information if you contact Allied
Telesis Technical Support for assistance.
Figure 45. DIAGNOSTICS SHOW CHASSIS EEPROM Command
Slot
Module
Module
Serial
HW
MAC
ID
Name
Type
Number Rev
Address
----------------------------------------------------------------------
C
AT-MCF2000
A03678L072000004
A
00:15:77:70:7A:2A
M
AT-MCF2000M
5A
A
00:15:77:70:7A:2B
1
Reg 1 Traf
AT-MCF2012LC
20
A
00:15:77:70:7A:2C
2
Reg 2 Traf
AT-MCF2012LC
14
A
00:15:77:70:7A:2D
A
AT-MCF2KFAN
8
A
B
AT-MCF2000AC
68
A