Allied Telesis AT-S97 - Manual (Page 58)

Chapter 4: General System Commands
58
SYSTEM SET ASYNCHRONOUS
Syntax
system set asynchronous baudrate=2400|4800|9600|19200|115200
Parameters
baudrate Specifies the new baud rate of the RS-232 Terminal port on
the AT-MCF2000M Management Module. The default is
115,200 bits per second (bps).
Privilege Levels
Administrator and read-write.
Description
This command is used to change the baud rate of the RS-232 Terminal
port on the AT-MCF2000M Management Module. The port is used to
locally manage the chassis. To view the port’s current baud rate setting,
refer to “SYSTEM SHOW ASYNCHRONOUS” on page 66.
Note
If you change the baud rate of the RS-232 Terminal port on the
management module while conducting a local management
session, the session is interrupted. To resume managing the
module, change the speed of the terminal or the terminal emulator
program to the new speed of the RS-232 Terminal port.
The other settings of the RS-232 Terminal port listed here are not
adjustable:
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
Example
This command sets the baud rate of the RS-232 Terminal port to 2,400
bps:
system set asynchronous baudrate=2400