Allied Telesis AT-S97 - Manual (Page 123)

AT-S85 and AT-S97 Management Software User’s Guide
123
NTP SHOW
Syntax
ntp show
Parameters
None.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command is used to display information about the NTP client on the
management module. The information includes the status of the client, the
IP address of the NTP server, and the UTC offset. An example is shown in
Figure 20.
Figure 20. NTP SHOW Command
Example
ntp show
NTP Information:
Status ............. Disable
Server ............. 0.0.0.0
UTC Offset .......... 0