Allied Telesis AT-S97 - Manual (Page 108)

Chapter 5: Port and Module Commands
108
Description of the Chassis, Slot, and Channel Command
To view the operating parameters of the channel’s two ports, including the
speeds and duplex modes, specify a channel number in the command.
You can view only one channel at a time. Figure 16 is an example of the
information.
Figure 16. SYSTEM SHOW INTERFACE Command - Chassis ID, Slot
Number and Channel Number
The fields are defined here.
Interface 0/2/7 Information
Chassis ID ............... 0
Slot ID .................. 2
Module Name .............. User Module
Module Type .............. AT-MCF2012LC
Port Name ................ User Port
OpMode ................... Link Test
Port Copper Link
Port State .......... Enabled
Link Status ......... Online
Auto Negotiation .... Enabled
Speed ............... 100 Mbps
Duplex .............. Full
MDI Crossover ....... MDI
Ingress Rate Limit .. No Limit
Egress Rate Limit ... No Limit
Maximum Frame Size .. 1632 bytes
Port Fiber Link ....
Port State .......... Enabled
Link Status ......... Online
Speed ............... 100 Mbps
Duplex .............. Full
Ingress Rate Limit .. No Limit
Egress Rate Limit ... No Limit
Maximum Frame Size .. 1632 bytes
Table 12. SYSTEM SHOW INTERFACE Command - Chassis ID, Slot Number and Channel
Number
Parameter Description
Interface Information Displays the identity number of a channel. The information is
given as chassis number, slot number, and channel number.
Chassis ID Displays the ID number of a chassis.
Slot ID Displays the slot number of a media converter module.
Module Name Displays the name of a module. To assign a name, refer to
“SYSTEM SET MODULE” on page 89.