Allied Telesis AT-S97 - Manual (Page 196)

Chapter 9: File System Commands
196
settings are overwritten by the master configuration file on the
management module after the file is installed on a media converter
module. For further information on configuration files, refer to “Overview”
on page 146.
Description of Syntax 2
This command syntax is reserved for future versions of the management
software.
Examples of Uploading a Configuration File to a TFTP Server
This command uploads the master configuration file “traffic_n2.cfg” from a
management module to a TFTP server with the IP address of
150.24.44.65. The chassis has the ID number 0:
file upload srcfile=system://0/m/traffic_n2.cfg
dstfile=tftp://150.24.44.65/traffic_n2.cfg
This command uploads the master configuration file “mic traf ata.cfg” from
the management module of a chassis with an ID number of 0. The IP
address of the server is 149.72.23.5 and the name of the file is changed to
“mic traf bc.cfg on the TFTP server:
file upload srcfile=system://0/m/"mic traf ata.cfg"
dstfile=tftp://149.72.23.5/”mic traf bc.cfg”
Note
The following example shows how to upload an auxiliary
configuration file from a media converter module. This function
should never be necessary.
This command uploads the auxiliary configuration file “BM.cfg” from a
media converter module in slot 1 of a chassis with an ID number of 0:
file upload srcfile=system://0/1/BM.cfg
dstfile=tftp://150.24.44.65/BM.cfg