Allied Telesis AT-S97 - Manual (Page 71)

71
Chapter 5
Port and Module Commands
This chapter contains the following sections:
ˆ “Overview” on page 72
ˆ “SYSTEM RESET CHASSIS” on page 74
ˆ “SYSTEM RESET CLUSTER” on page 76
ˆ “SYSTEM RESET MODULE” on page 78
ˆ “SYSTEM SET INTERFACE” on page 81
ˆ “SYSTEM SET INTERFACE PORTNAME” on page 87
ˆ “SYSTEM SET MODULE” on page 89
ˆ “SYSTEM SET PORT” on page 92
ˆ “SYSTEM SHOW CHASSIS” on page 99
ˆ “SYSTEM SHOW CLUSTER” on page 101
ˆ “SYSTEM SHOW INTERFACE” on page 103
ˆ “SYSTEM SHOW MODULE” on page 111
Note
Remember to save your parameter changes in the active master
configuration file with the CONFIG SAVE command. For information,
see “Saving Your Configuration Changes” on page 23 or Chapter 8,
“Configuration File Commands” on page 145.