Allied Telesis AT-S97 - Manual (Page 162)

Chapter 8: Configuration File Commands
162
CONFIG SAVE FILESYSTEM
Syntax
config save filesystem=system:// chassis / slot / filename .cfg
Parameter
filesystem Specifies a location and a name for a new master
configuration file. The parameter consists of the following
parts:
chassis Specifies an ID number of a chassis with a
management module. The ID number is
either 0 or 31.
slot Identifies a slot with a management module.
The only supported value for the slot is:
m Identifies the management
module slot and the
AT-MCF2000M Management
Module.
filename.cfg Specifies a name for a new master
configuration file. The name can be up to 15
alphanumeric characters, not including the
extension. Spaces are allowed, but a name
with spaces must be enclosed in double
quotes. The filename must include the
“.CFG” extension. Configuration filenames
are case sensitive.
To view the ID number and the slot numbers of a chassis,
refer to “SYSTEM SHOW CHASSIS” on page 99 or
“SYSTEM SHOW CLUSTER” on page 101. To view the
filenames of the current configuration files in a file system
on a module, refer to “FILE SHOW” on page 191.
Privilege Levels
Administrator and read-write.
Description
This command is used to create a new master configuration file containing
the current parameter settings of all the modules in a chassis or stack. The
file is stored in the file system on the management module. For
background information, refer to “Overview” on page 146.