Allied Telesis AT-S97 - Manual (Page 211)

AT-S85 and AT-S97 Management Software User’s Guide
211
ˆ The management module must have an IP configuration. For
instructions, refer to Chapter 3, “IP Configuration Commands” on page
47.
ˆ The remote SSH management workstation must be a member of the
same network as the management module or have access to it
through Layer 3 routing devices.
ˆ If the management module and the remote SSH management
workstation are on different networks, the IP configuration on the
module must include a default gateway address specifying the IP
address of the routing interface of the first hop to reaching the
workstation. For instructions, refer to Chapter 3, “IP Configuration
Commands” on page 47.
ˆ The management module can support up to 20 Telnet and 20 SSH
concurrent management sessions.
Command
Summary
Table 23 summarizes the SSH server commands.
Table 23. Secure Shell Server Commands
Command Description
SSH DISABLE on page 212 Deactivates the SSH application
protocol server.
SSH ENABLE on page 213 Activates the SSH application
protocol server.
SSH SHOW on page 214 Displays the current settings of the
SSH server.