Allied Telesis AT-S97 - Manual (Page 67)

AT-S85 and AT-S97 Management Software User’s Guide
67
SYSTEM SHOW CLOCK
Syntax
system show clock
Parameters
None
Privilege Levels
Administrator, read-write, and read-only
Description
This command is used to display the current date and time on the
management module. An example of the information is shown in
Figure 10. The Real Time Clock (RTC) Source field indicates the source of
the date and time. The field will be “none” if the date and time were set
manually. If they were set by an NTP server, the RTC Source field will be
“NTP.”
Figure 10. SYSTEM SHOW CLOCK Command
To manually set the date and time, refer to “SYSTEM SET CLOCK” on
page 60. To set the date and time from an Network Time Protocol (NTP)
server, refer to Chapter 6, “Network Time Protocol Commands” on page
117.
Example
system show clock
System Clock Information
Date ............. 06/04/2007
Time ............. 03:35:25
RTC Source ....... none