Ntp set – Allied Telesis AT-S97 User Manual
Page 122
Chapter 6: Network Time Protocol Commands
122
NTP SET
Syntax
ntp set server=
ipaddress
utcoffset=
integer
Parameters
server
Specifies an IP address of an NTP server. To delete the
current value without specifying a new value, enter
“0.0.0.0”.
utcoffset
Specifies a time difference, in hours, between the Universal
Time Coordinated (UTC) and the local time zone. The
range is from -12 to +12 hours. The default is 0 hours.
Privilege Levels
Administrator and read-write.
Description
This command is used to specify an IP address of a NTP server on your
network or the Internet, and a time offset between the UTC and the local
time zone.
Examples
This command specifies the IP address of the NTP server as
149.122.55.77:
ntp set server=149.122.55.77
This command specifies the IP address of the NTP server as
149.122.55.79 and a UTC offset of 3 hours:
ntp set server=149.122.55.79 utcoffset=3
This command specifies the IP address of the NTP server as
149.122.55.81 and the UTC offset of -6 hours:
ntp set server=149.122.55.81 utcoffset=-6