Allied Telesis AT-S97 - Manual (Page 101)

AT-S85 and AT-S97 Management Software User’s Guide
101
SYSTEM SHOW CLUSTER
Syntax
system show cluster
Parameters
None.
Privilege Levels
Administrator, read-write and read-only.
Description
This command is used to display the model names and slot assignments
of the management and media converter modules in a chassis or stack, as
well as the chassis’ module name and MAC address. This command does
not display any information about the stacking, power supply, or fan
modules.
This command is similar to the SYSTEM SHOW CHASSIS command in
that both commands display the same information about a chassis. Where
they differ is that the SYSTEM SHOW COMMAND can display only one
chassis at a time and requires a chassis ID number. In contrast, this
command displays all of the chassis of a stack and does not require an ID
number.
The SYSTEM SHOW CLUSTER command is typically used to view the
basic information above on a single chassis that is not part of a stack or for
all of the chassis of a stack. The SYSTEM SHOW CHASSIS command is
intended for situations where there is a stack and, rather than viewing all of
the devices, you want to focus on just one of the units.
Figure 13 on page 102 illustrates this command on a stack of three
chassis. For an explanation of the information, refer to “SYSTEM SHOW
CHASSIS” on page 99.