Allied Telesis AT-S97 - Manual (Page 206)

Chapter 11: Simple Network Management Protocol (SNMP) Commands
206
SNMP SET
Syntax
snmp set mgrip1= ipaddress mgrip2= ipaddress mgrip3= ipaddress
mgrip4= ipaddress Get-community= string Set-community= string
Trap-community= string
Parameters
mgrip1 - mrip4 Sets the IP addresses of up to four trap receivers.
The IP addresses have to be entered in the
following format: xxx.xxx.xxx.xxx To replace a
current value without entering a new value, enter
the default value, 0.0.0.0. This parameter is
optional.
Get-community Sets the get community string. The string can be up
to 14 alphanumeric characters. The string is case
sensitive and can contain special characters,
including spaces. However, a community string with
spaces must be enclosed in double quotes (“ “). The
default value is “public.”
Set-community Sets the set community string. The string can be up
to 14 alphanumeric characters. The string is case
sensitive and can contain special characters,
including spaces. However, a community string with
spaces must be enclosed in double quotes (“ “). The
default value is “private.”
Trap-community Sets the trap community string. The string can be up
to 14 alphanumeric characters. The string is case
sensitive and can contain special characters,
including spaces. However, a community string with
spaces must be enclosed in double quotes (“ “). The
default value is “public.”
Privilege Levels
Administrator and read-write
Description
This command is used to set the SNMPv1 and SNMPv2c community
strings and to specify the IP addresses of up to four trap receivers.