Allied Telesis AT-S97 - Manual (Page 31)

AT-S85 and AT-S97 Management Software User’s Guide
31
If multiple chassis are linked together with the AT-MCF2000S Stacking
Module to form a stack, this command displays all of the enclosures and
the modules in the stack. Here is an example of a stack with three chassis.
Figure 6. Displaying the Chassis Modules of a Stack
For information about this command, refer to “SYSTEM SHOW
CLUSTER” on page 101.
Note
To avoid possible compatibility problems between the management
module and the media converter modules, Allied Telesis
recommends that all of the modules in a chassis or stack use the
same version of the AT-S85 and AT-S97 Management Software. If
the modules shown in the SYSTEM SHOW CLUSTER command
have different versions, you should upgrade the operating software
on the modules. For instructions, Chapter 9, “File System
Commands” on page 169.
Chassis Chassis Chassis MAC Master
ID Name Type Address Chassis
--------------------------------------------------------------------------
0 AT-MCF2000 11:22:33:44:55:55 Yes
AT-MCF2000
Slot ID Module Name Module Type Cfg Overwrite Software Version
----------------------------------------------------------------------
M
AT-MCF2000M v3.0.0
1 AT-MCF2012LC Enable v3.0.0
2 AT-MCF2012LC/1 Enable v3.0.0
1 11:22:33:44:22:22 No
AT-MCF2000
Slot ID Module Name Module Type Cfg Overwrite Software Version
----------------------------------------------------------------------
1
AT-MCF2012LC Disable v3.0.0
2 AT-MCF2012LC Disable v3.0.0
2 11:22:33:44:66:77 No
AT-MCF2300
Slot ID Module Name Module Type Cfg Overwrite Software Version
----------------------------------------------------------------------
1
AT-MCF2012LC Enable v3.0.0
2 AT-MCF2012LC Enable v3.0.0
3 AT-MCF2012LC Enable v3.0.0
4 AT-MCF2012LC/1 Enable v3.0.0